The specific statements show in each section of this description are not intended to be all-inclusive. They represent typical elements and criteria considered necessary to perform the job successfully. Smeal Fire Apparatus recognizes that an individual with a disability may require an accommodation the enable him/her to successfully perform a job function. Consideration will be given to reasonable accommodations.

Essential Job Functions:

• Follow standard operating procedures as well as written and verbal orders and instructions in English.
• Lift up to 75 lbs. and be in good physical condition. Standing, bending, and climbing as well as upper body and back strength required.
• Follow all company policies and procedures as stated in the company policy and safety manual including wearing safety glasses, ear protection, and steel toed shoes.
• Able to work in a noisy environment.
• Work overtime as needed.
• Actively pursue cost reduction measures.
• Perform all assigned tasks within specific time limits and company standards.
• Must be able to read a tape measure.
• Must comply with all safety regulations regarding the work area, the product and equipment. Recognize and report all safety discrepancies to your supervisor.
• Willing to develop a thorough knowledge of all aspects of this field including products, options, & uses.
• Ability to learn how to read and understand simple blue prints.
• Ability & willingness to be cross trained in respective departments.
• Able to learn about parts and where they are used as well as the number required per assigned task.
• Communicate with department leaders when items run low in order to restock/reorder parts.
• Possess some prior experience from outside of the company or has mastered all the required skills at the previous level in order to advance.
• Willingness to share department and company knowledge as needed.
• Ability to write down information for future reference.

Daily Functions:

• Ability to learn, read and fully comprehend complex electrical schematic diagrams and use them to diagnose and troubleshoot problem areas.
• Able to learn about the complete truck chassis electrical system including changing or starting and load management systems.
• Can learn to use test equipment.
• Able to acquire a basic knowledge of electronic controls used on transmission and engines. The use of the data reader and laptop may require further education to keep updated on changes in vehicle electronics.
• Mount and wire equipment on truck and run/route wiring harnesses throughout the truck body using small hand tools. Requires wrist strength.
• Install and wire equipment including but not limited to lights and light mounts, generator set systems, and intercom systems, including radio interfaces.
• Possess a basic knowledge of basic electric tools, crimpers, side cutters, wire gauge, & pulling wires.
• Ability to consistently read a tape measure accurately.
• Ability to read blueprints, & shop orders etc.
• Ability to run wire in conduit.
• Ability to use a fish tape.
• Ability to identify colors.

Potential Hazards:

• Eye injuries: use eye protection at all times.
• Cuts & burns: Use caution to prevent cuts when sanding and wear PPE when welding to protect against burns.
• Trips, slips, & falls: ensure all air hoses and obstacles are kept clear of aisles. Use caution when climbing on and off trucks.
• Shock: electrical charge can occur if equipment is not used correctly.
• Repetitive motions: correctly use hand tools to prevent injury.

Additional Responsibilities:

Perform other duties as assigned.

This description reflects the principal functions of the job for purpose of job evaluation. It should not be construed as a detailed description of all work requirements of the job nor shall be construed as giving exclusive responsibility for every function described.

Job Type: Full-time

Pay: $17.50 - $24.00 per hour

Expected hours: 40 per week

Benefits:

• 401(k)
• 401(k) matching
• Dental insurance
• Health insurance
• Life insurance
• Paid time off
• Vision insurance

Schedule:

• 10 hour shift
• Morning shift
• Overtime

Travel requirement:

• No travel

Ability to Commute:

• Snyder, NE 68664 (Required)

Work Location: In person