Assembler Advanced (Franklin WI) 

Job Summary 

In this job you will perform a variety of assembly and test positions for IntelliRupter and Power Quality products. You will work in a production environment, engage in continuous productive activity, and must meet requirements within time constraints. Considerable initiative required to run and process all IntilliRupter units through test and assembly cells, a fast paced multi station process.

Tasks require a high degree of eye-hand coordination, manual dexterity, and the use of both hands and arms on a repetitive basis for a full range of motion. You will frequently use hand and power tools; occasionally work while standing on ladders; and occasionally work inside tight compartments.

The responsibilities of this position include, but are not limited to, the following:

• Assemble and test IntelliRupter products based on the documentation including bills of material, blueprints and any change notices provided by the engineering staff.
• Complete testing at timing stations and run switch through 4 operations station.
• Complete mechanical work including disconnect assemblies.
• Experience troubleshooting electrical issues

You will be performing the following tests:

• Timing Test capacitor voltage 425 DC
• Partial Discharge Test AC voltage 50KV
• Dielectric test 3 phase AC voltage 60KV-70KV
• Calibration test parallel AC voltage 8.7KV-18KV in series 600 amps.
• 3 phase AC high voltage 8.7KV -18KV with 20 amps – 45 amps. 
• Low voltage test capacitor voltage 425 DC

To select this job as one of interest to you, at a minimum, you must have the following:

• High voltage electrical experience is required to run the required test cells. 5KV / 3phase
• Demonstrate the ability to work from complex blueprints, wiring drawings, schematic diagrams, and specifications.
• Demonstrate knowledge and experience to troubleshoot mechanical or electrical issues. 
• Demonstrate experience using and operating machining tools, hand-held tools, wiring equipment, wrenches, torque tools, and other tools. 
• Must follow all S&C safety standards. 

• Relevant Work Experience:Two years of experience in electronic assembly and wiring with 5KV
• 2 year technical degree preferred. 
• Candidates with electrical or mechanical trade school education may also be considered in lieu of experience 

MAJOR PHYSICAL DEMANDS

• Standing: Most tasks are performed in a standing position with intermittent walking.
• Lifting: Frequent lifting of items ranging in weight from 5 lbs. to 40 lbs.
• Walking: Frequent walking of short distances to obtain parts for assembly.
• Carrying: Occasional carrying of items ranging in weight from 5 lbs. to 25 lbs.
• Pushing: Occasional pushing of handcart to/from assembly area containing up to 50 lbs.
• Pulling: Occasional pulling of handcart to/from assembly area containing up to 50 lbs.
• Bending: Frequent bending and crouching required to complete the assembly/wiring tasks.
• Reaching: Continuous full range of motion from above the shoulders to below the knees.
• Handling: Continuous handling of parts (all sizes) along with a variety of hand tools.