** PAY RATE: ***/hr

Work with a team of Technicians and Engineering Resources in Electronic Test to build / fabricate / repair Test Equipment in the eFab (Electronic Fabrication group), This includes supporting customers across Engineering and ISC. This also includes the full range of tasks from replacing a broken pin on a connector, to working on a CCA, to building a full-up ATE and all the sub-assemblies going into it.

Below is a high-level summary of responsibilities and skills needed.

This includes assembly, modification, repair of the following:
•Cable Harnesses
•Circuit Cards including delicate and micro-electronics
•Break-out Boxes / Test Adapters
•Power Controllers
•Full-up Test Stations / Racks
•EMI Fixtures
•Micro-Electronics

Candidates should possess the following skills / familiarity:
•Able to read and understand electrical schematics and prints
•Able to read and understand mechanical schematics and prints
•Knowledge and use of crimping tools, soldering iron, cutters / strippers, mechanical tools, volt-meter, continuity testers, label maker, etc.
•Experience building / fabricating Test Equipment assemblies
•Experience working on red-label products
•Experience with electronic troubleshooting and repair
•Work directly with engineering with build recommendations and offer problem solving solutions
•Familiar with IPC standards and/or IPC certified
•Familiar with SAP
•Computer savvy