This individual will assume responsibility for technical assignments for the design and development of
semiconductor and disk media product power supplies and systems. This is a senior level position requiring
experience with capital equipment electrical systems, switching power supplies and RF generators. Typically
works under minimal supervision in a diverse team (mechanical, software, process, & manufacturing).

Primary Job DutiesRequired Experience:

• 6-10 years of experience designing commercial power electronics products
• High-power semiconductor switches (SCR, IGBT, BJT, MOSFET, etc.)
• Cable Design and system interconnect
• Design with safety standards for high power
• Create ECO's
• Use of test equipment (oscilloscopes, volt meters, impedance, frequency generators) to
  troubleshoot designs
• Design cables and boards for vacuum components (gauges, MFC's, valves, turbo controllers)
• Use software like Agile or Omnify configuration control
• Layout industrial networks (Beckhoff & Siemens) like Ethercat & Profinet
• Use of PLCs
• Design safety interlocks

Minimum Requirements:

Typically requires a Bachelor's degree in Engineering, Physics or other related technical discipline, plus (6-
10) years' experience, or an equivalent combination of relevant technical education and experience such
as a Masters Degree plus five (5) years experience or a Ph.D. degree.

Preferred Experience Experience with electrical systems design/troubleshooting on typical semiconductor tools including RF
plasma, PVD, CVD, and etch processes
 Design for EMI, EMC safety compliance
 PCB design with Altium
 High-power RF circuit design up to 13.56MHz
 Knowledge of high and low pass filter design, signal conditioning and noise mitigation
 Microcontroller and DSP design
 Digital, analog, & mixed design
 PDU design experience 480VAC is a plus

KEY OBJECTIVES FOR FIRST 6 MONTHS Support the RF LURMA Match and Source build, testing and CIP
 Support dNCT and NCT controllers
 REI-ICP Source Match Design
 Become familiar with Intevac's ECO process and required documentation.
 Become familiar with Intevac technology and product offerings.

SAFETY EQUIPMENT/TRAINING REQUIREMENTS1. Standard Safety Training
2. Ergonomics