Overview

Perform machine tending operations and processes; count, stage and record finished parts. Remove burrs and sharp edges from manufactured parts using hand grinders, dynafiles, Burr Master and Tumbler.

Responsibilities

• Pull finished laser cut parts from the load tables and stack on carts.
• Operate hand/air tools and electric grinders.
• Verify part counts to the number of parts nested by the laser programmer.
• Locate parts that have fallen to the ground through the table grates.
• Accurately complete the Work Order paperwork.
• Attach applicable part tags.
• Move laser cut parts to the correct locations based on the next operation as dictated on the Job Travelers.
• Empty the slag pans daily.
• Clean the floor under the load table daily at specified time(s).
• Complete daily 5S requirements.
• Clean the lasers weekly.
• Assist in other duties as requested by trainer, manager or supervisor.

Qualifications

Education and Experience:

• High school or general education degree (GED).
• Machine shop experience is a plus.

Skills and Abilities:

• Read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals.
• Complete standardized written documentation and correspondence.
• Professionally communicate in one-on-one and small group situations.
• Ability to perform basic electronic tasks using computer software and Microsoft Office.

Working Conditions/Physical Demands:

• Environment is a modern production facility with heat and air conditioning
• While performing the duties of this job, the employee is generally required to stand; use hands and fingers to manipulate raw materials, finished parts and cutting tools
• Ability to twist at the waist 180 degrees (side to side) repetitively
• Ability to squat/bend and lift up to 15 pounds to place parts on machine at chest level repetitively
• Ability to lift 16 to 50 pounds occasionally
• Ability to squat and lift up to 75 pound fixtures to place on machine at chest level occasionally, with assistance
• Ability to reach over head with one arm to adjust setup dial regularly