Facility Maintenance Technician 2nd Shift 1

• Dedication to Safety

• Weld and fabricate all modifications

• Make all necessary repairs and preventive Maintenance checks for facilities

• Troubleshoot, maintain, and repair fire pump, sprinkler systems, and monitoring panel

• Assist other departments with needed repairs

• Apply 5S Standards to plant facilities

• Attend all classes and training required by Plastic Omnium

• Install and maintain a wide variety of complicated electrical, electronic, transmission testing and control equipment, single or 3-phse, up to maximum voltage used in plant and various departments

• Diagnose and solve any type of electrical or electronic trouble with switchboards, test boards, motors, starters, switches, circuits and controls

• Install conduit and wiring, piping and hydraulic systems

• Build from wiring diagrams and sketches, large single phase and 3-phase equipment

• Diagnose and repair breakdowns to electrical, hydraulics equipment in any department

• Keep up with existing changes in Nation Electrical Code

• Operate a variety of power tools including grinders, drills drill presses, back saws and do-all saws

• Responsible for rigging and moving machinery and accurate installation of machinery

• Assure all equipment is properly lubricated and maintained in plant facility

• Responsible for continuous service of compressed air, water, heat, and air conditioners

• Troubleshoot, maintain, and repair on all overhead cranes

• Troubleshoot, maintain, and repair all chilled water, cooling towers, and HVAC systems COMPETENCIES

• High School Diploma/GED, Associates preferred

• Requires ability to check general conditions as to wear, diagnose bearing wear, shaft conditions, etc.

• Knowledge of TS 16949, ISO 14001 and 18001

• Must be able to wear a personal harness