Construction Manager

Kentucky Lock Addition Civil Works Mega Project at the Kentucky Lock Area Office

Serve as a Senior Construction Representative, delivering field construction inspection services for the Kentucky Lock Addition Civil Works Mega Project. The current award contract is valued at approximately $400 Million. Duties are described below. Specific duties include, but are not limited to:

QUALITY ASSURANCE INSPECTIONS

a. Inspect on-going construction through on-site visits and review of construction contractor’s completed reports, test results, etc.

b. Independently inspect a variety of unusually difficult and complex ongoing construction that demands specialized competence and technical expertise in unusually complex construction operations.

c. Assure construction contractor’s work complies with the accepted construction schedule, the awarded construction plans and specifications, applicable safety regulations, and other applicable contract documents.

d. Inspect the materials, installation, and testing of completed work for contract compliance and work closely with Contractor representative to identify and ensure correction of deficiencies, and to suggest and advise on acceptability of alternative construction methods.

e. Review the construction contractor’s daily quality control reports to assure that the control operations are adequately documented (including such activities as level of inspection, documentation, deficiency correction, etc.). Perform and document surveillance to ensure the construction contractor is adequately following the USACE 3-phase quality control system. Provide daily quality assurance inspection (follow-up inspections) and surveillance of construction contractor’s Quality Control Program.

f. Review ongoing work activities to verify that materials and workmanship conform to contract requirements.

g. Attend quality assurance preparatory and initial inspections. Within 24 hours of an inspection, provide input on the daily Quality Assurance Report (QAR) via USACE Resident Management System (RMS), with particular emphasis on deficiencies found.

h. Verify site location, layout, and elevations of contract work prior to start of work. Verify that all QC requirements, including those established in the preparatory inspection, are in effect prior to the start of work.

i. Monitor construction contractor’s procedures for tracking deficiencies to assure acceptable corrective action and that an audit trail is maintained. Report findings on daily logs of construction Quality Assurance Reports.

j. Maintain a system for tracking deficiencies, field problems, and requests for information (RFIs).

k. Occasionally attend shop inspections for offsite fabricated items in support of the project pertaining to construction assemblies to verify contract compliance before shipment to site. These site visits are expected to be multi-day trips requiring alternate overnight travel arrangements. Note: Any requested overnight travel will be negotiated separately once the location and duration are known.

GENERAL RESPONSIBILITIES

a. Attend and participate in technical reviews, construction conferences, quality control coordination meetings, in-progress reviews, and other conferences and meetings with construction contractors and USACE personnel.

b. Participate in the Activity Hazard Analysis (AHA) discussion and decisions.

c. Participate in progress payment reviews for work achieved by construction contractor.

d. Perform submittal reviews for complex submittals.

e. Participate in risk management for critical construction lifts.

f. Review construction contractor as-built drawings to ensure they are current and up to date.

g. Maintains working knowledge of EM 385-1-1 (USACE Safety and Health Requirement s Manual) and OSHA Construction Industry Regulations.

h. Prepare and sign daily reports to ascertain contractor progress on work performed.

i. Make recommendations for the Construction COR and ACO to accept or reject ongoing and completed work.

j. Ensure the Construction COR makes the final determination on interpretation of plans and specifications.

k. Independently conduct labor standard interviews to ensure compliance with Contract Labor Rates.

l. Independently inspect a specifically assigned standardized process such as conduit installation, electrical or equipment installation.

m. Attend USACE Three Phase Quality Control Process inspection meetings.

n. Serve as a mentor and provide guidance to less experienced staff in technical construction and quality assurance duties.

o. Independently check contractor payrolls for accuracy against what the contract documents require.

p. Independently inspect inventories of installed property to assure compliance with contract documents.

q. Attend all safety meetings scheduled for this project.

r. Maintain orderly working files for correspondence, minutes of meetings and conferences, submittal data, submittal registers, inspection and monthly progress reports, punch list and contract documents including amendments, notices to proceed, change orders, and modifications.

s. Maintain updated set of plans and specifications including all amendments, modifications, issued clarifications, and significant as-built notations. Conduct review of the construction contractor’s maintenance of accurate as-built drawings and provide comments on completed as-built drawings on a monthly basis.

t. Participate and take notes at pre-final and joint final inspections with customer. List and verify all punch list items are corrected prior to final payment. Perform a detailed comprehensive final acceptance inspection upon completion of all work required in the contract.

u. Prepare correspondence for USACE signature to construction contractors and other Government activities to implement actions relative to contract and project execution. All correspondence should be submitted in final form. This includes replies to requests for information (RFIs) and construction contractor’s discussion of contract requirements.

v. Monitor timeliness of construction contractor response to letters, transmittals, and other inquiries. Identify tardiness and corrective action that should be taken.

w. Prepares correspondence for the Project Office ACO/COR's signature.

x. Take possession of Government provided equipment, such as a computer, and maintain devices during work, ensuring all devices are cared for and returned in the same condition in which the devices were issued.

y. Within 2 months of starting support services, contract personnel shall complete First Aid / CPR and USACE Construction Quality Management (CQM) training.

The period of performance for the basic scope of work is twelve-months, with four (4) additional twelve-month option periods to extend the period of performance.

Experience and Skill Requirements:

• Field inspections to determine acceptability of workmanship and compliance with plans and specifications.
• Interpretation of plans and specifications and review of as-built drawings.
• Reviewing contractor daily quality control reports for accuracy and deficiencies and performing quality assurance inspections.

Education and Certifications: The Senior Construction Representative shall have at minimum the following:

• A minimum of 15 years of experience in the construction industry.
• OSHA 30 Certification
• High School Diploma
• Valid driver’s license
• Specialized experience with heavy civil construction experience.
• Note any relevant experience and certifications regarding concrete construction operations.
• Familiarity with EM 385-1-1 (USACE Safety and Health Requirements Manual) and 29 CFR 1926 OSHA Construction Industry Regulations