Entry Level Production Operator

Job Description

Summary/Objective

PWT is a manufacturer of Engineered Wood Products (EWP). This job’s primary goal is to make good wood safely. Operators work 12-hour shifts. Shifts rotate monthly (7am-7pm and 7pm-7am). Operators rotate positions approximately every hour between 3 positions listed below.

Required PPE: Hard hat, gloves: type depends on task, googles/safety glasses, above the ankle steel toe boots, and ear plugs.

Essential Functions

Reasonable accommodations may be made to enable individuals with disabilities to perform these essential functions.

• Lay Up Operator Duties:
• Straighten and guide veneer as it travels down conveyor and hits lay-up stop.
• Visually inspect quality of veneer.
• Remove broken sheets of veneer and place on reject cart.
• Replace broken veneer with quality sheets from staged bundle cart.
• Ensure quality of layup, veneer quality and billet construction per menu requirements.
• Operate layup controls.
• Keep line free of broken veneer.
• Roll glue on veneer using paint type roller where glue is missing.
• Feeder Operator:
• Operate feeder controls to ensure steady flow of veneer.
• Monitor line and veneer as it is fed onto the line.
• Verify bins contain proper grade of veneer.
• Set and maintain LVL line controls.
• Staple glue card to veneer.
• Unclog jams in feeder bins.
• Straighten veneer sheets.
• Lay Up Assistant Operator
• Assist layup operator monitoring line.
• Unclog jams – Jams may include removing multiple sheets of veneer at the same time.
• Sort and stack veneer sheet rejects onto cart.
• Pull defective sheets of veneer off the line and carry to cart.
• Remove and replace defective veneer face sheets.
• Inspect veneer for defects; remove sheets out of spec.
• Housekeeping: Use air hose to blow out debris and dust from underline.
• Maintain good housekeeping; sweep, dump trash, and use air wand to blow out debris and dust from under line.
• Sweep floor using push broom.
  
  

Competencies

• Team player
• Safety Oriented
• Attention to Quality
  
  

Supervisory Responsibilities

None

Work Environment

• Manufacturing Environment
• Limited Temperature Regulation
• Wood dust
  
  

Physical Demands

• Must be able to lift, push, and pull up to 50 lbs
• Must be able to stand for long periods of time
• Must be able to climb stairs
• Must be able to able to work in hot & cold environments
  
  

Education and Experience

• Manufacturing experience preferred
  
  

Work Authorization/Security Clearance Requirements

Must be authorized to work I the US.