Hand Finisher I/DeBurr Technician

As a Hand Finisher, you will deburr, sand and clean parts on repeat or proven part(s) with simple to high complexity on a various materials such as aluminum, steel, plastic and copper with direction from area Lead or Supervisor. 

ESSENTIAL DUTIES: 

· Ability to communicate with production lead and supervisor 

· Follow instructions 

· Responsible for utilizing shop paper procedure including updates, signatures and stamps, counting quantities, labeling and non-conformance related activities 

· Ensure an accurate router accompanies all work orders 

· Ensure company procedures and “best machine practices” are being followed and are in place at all times.

· Assist Lead person as needed 

· Read blueprints, tooling instructions, and standard charts for specifications · Follow blueprint or instructions to achieve required surface finishes such as lay patterns and sealing surfaces. 

· Work independently to complete repeat tasks with little supervision.

· Operate a variety of pneumatic or electric power finishing tools such but not limited to orbital sander, DA sander, flappers and die grinders. 

· Ensure company procedures and “best machine practices” are being followed and are in place at all times 

· Comply with applicable environmental, health and safety laws and regulations, Company policy and accepted safe work practices · Perform additional related duties as assigned 

RECOMMENDED CERTIFICATES, LICENSES AND REGISTRATIONS: · Completion of vocational education for machine technology or practical aspects of blueprint reading, GD&T preferred.

EDUCATION AND/OR EXPERIENCE REQUIRED: 

· High school diploma or general education degree (GED) 

· Previous finishing experience of 3-5 years preferred

· Ability to read and comprehend basic instructions. 

· Ability to speak basic English language. · Basic math and counting skills. 

· Knowledge of Shop safety practices and use of PPE 

· Enrolled in vocational education for machine technology or practical aspects of blueprint reading, GD&T preferred. · Basic knowledge of abrasive(s) progression required to achieve specific surface finishes.

PHYSICAL DEMANDS WHILE PERFORMING THE JOB: 

· Use of hands to handle, deburr, and finish parts 

· Frequently required to stand, walk, push, reach overhead, and bend to the floor 

· Frequently required to sit and use hands to finger, handle, or feel objects, tools, or controls 

· Occasionally lift and/or move up to 40 pounds 

· Specific vision abilities: close vision, depth perception, and adjust focus 

WORKING ENVIRONMENT OF THE JOB: 

· High noise levels from operating machines 

· Physical hazards from moving equipment and machine parts