Quality Tester

Job Title: Quality Tester
Location: Waukesha, WI
Zip Code: 53188
Duration: 12 Months
Pay Rate: $25.95/hr
Keyword's: #Waukeshajobs; #Testerjobs.
Start Date: Immediate

Job Description:
What you"ll do:
The Inspector/Tester performs assembly inspection of transformers/regulators at various locations in the
assembly plants per established procedures. You will perform electrical testing on assembled single and
three-phase transformers/regulators per established procedures and monitor conformance to quality
standards.

In this function, you will:
* Perform routine factory dielectric tests per established procedures, including OX (induced), QC
impulse, and hipot (applied potential).
* Perform routine factory loss tests per established procedures, including load loss (winding loss) &
no-load loss (core loss).
* Perform power factor, ratio, and resistance tests per established procedures.
* Perform operational tests on regulators as required.
* Perform continuity test on unit per established procedures.
* Follow routine tests inspect unit nameplate, stamp impedance value on nameplate, and secure nameplate to tested unit.
* Perform visual inspection on interior of unit upon completion of testing.
* Perform minor maintenance of test equipment.
* Perform special routine tests when required.
* Perform all responsibilities of the Inspector, including, but not limited to:
* Perform visual inspection of units throughout the assembly process per established procedures.
* Perform the following tests as required per established procedures: ratio, resistance, leak,
continuity, control box, insulation resistance, regulator sub-assembly, regulator modification,
regulator run-in.
* Apply decals and stencils to exterior of unit and perform paint mileage check as required.
* Assist Engineering and Manufacturing in identifying and resolving shop floor problems.
* Complete various company forms to communicate inspection status and other information and to
document inspection results per established procedures.
* Collect various types of data per established procedures as required

Qualifications:
Required (Basic) Qualifications:
* High school graduate or GED equivalent from an accredited institution.
* Minimum of 1 year of manufacturing experience
* Must be able to work in the United States without corporate sponsorship now and in the future.
* No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of
the work location will be considered. Active-Duty Military Service member candidates are exempt
from the geographical area limitation.

Preferred Qualifications:
* Education in AC/DC fundamentals or completion of electricity coursework from an accredited
institution or a minimum 1 year of experience in electricity

Skills:
* Ability to work overtime when required.
* Ability to lift up to 50 LBS; bend, twist, grab, reach, stand, walk, push, pull, use both hands to lift
and lower materials, and perform all other essential duties with or without reasonable
accommodations.

Belcan is an equal opportunity employer. Your application and candidacy will not be considered based on race, colour, sex, religion, creed, sexual orientation, gender identity, national origin, disability, genetic information, pregnancy, veteran status or any other characteristic protected by federal, state or local laws.