What are the responsibilities and job description for the Process Technician position at Sussex IM?
Process Technician – 1st and 3rd Shift
JOB DUTIES:
1. Responsible for sampling and debugging new molds. In addition, sets and records mold parameters and works closely with the engineers to resolve any mold issues.
2. Cycles-in machine. Examines the sample parts for defects, such as flash, sinks, shorts, splay, cracks, and closed holes, and adjusts machine setup to eliminate defects. Takes sample parts to Quality Assurance for approval.
3. Arranges the work area and assist in the setup of auxiliary equipment as required. Cleans the entire machine and washes the floor around the machine. All areas must be kept clean and safe.
4. Instruct operators on operating procedures and safety hazards as they pertain to each job after it is set up.
5. Twice during the shift, verify that all the molding parameters such as pressures, timers, water temperatures, and machine heats are properly set. In addition, make a quality check of the part for any defects. Troubleshoots operating difficulties by adjusting equipment and machine cycles to correct molding problems such as shorts, flash, etc...
6. At the completion of the run, responsible for removing mold from the press. Sprays mold with rust preventative disconnects water lines and blows water out of the mold. Responsible for storing mold in designated storage space.
7. Provides technical advice and assistance to Set-Up Technicians in setting up molds.
8. Performs other duties as required or assigned.
APPLICANT REQUIREMENTS:
1. High school diploma or equivalent preferred.
2. Must have completed the Set-Up Technician Apprenticeship Program or have equivalent work experience.
3. Ability to lift up to 75 lb. to shoulder height.
4. Good attendance and punctuality.
5. Minimum of 10 years of hands-on experience.