CMM Programmer

JOB TITLE:

CMM Programmer

CLASS:

A

DEPARTMENT/DIVISION:

Modern Machining Division

REPORTS TO:

Supervisor

EEO CATEGORY:

Operatives

CLASSIFICATION: Hourly Non-Exempt (paid overtime)

GENERAL:

Responsible for inspecting in process and finished parts to insure that customer requirements are met.

MINIMUM QUALIFICATIONS (Knowledge, Skills, Abilities):

Must have high school diploma or equivalent and three years minimum experience in performing dimensional inspections.Minimum 2 years CMM programming on prismatic machined component parts.Must demonstrate proficient performance of Class B Inspector essential duties.Must be proficient in current computer software.

ESSENTIAL DUTIES:

• Interpret drawings, control plans, process instructions and work instructions to determine sample quantities and features to be inspected for lots of parts.
• Program the CMM in support of new job launches and ongoing production, and train others as needed to do so.
• Use micrometers, calipers, visual inspection, and other gages as required to complete planned inspections.
• Identify and report conditions that do not meet requirements, and approve acceptable parts for shipment or further processing.
• Transfer rejected parts to staging area and log data into the ERP system.
• Verify implementation of appropriate correct action for quality issues.
• Maintain clean work areas and orderly storage of fixtures, gages and special inspection equipment.
• Wear personal protective equipment and follow safety instructions as required.
• Perform other duties as assigned.
  
  
  

PHYSICAL REQUIREMENTS:

• Must be able to lift parts and other items from floor to waist on a frequent basis, while protecting lifted items from damage. Parts weigh 50 lbs. on an occasional basis, 35 lbs. on a frequent basis.
• Must be able to stand for several consecutive hours without rest, with frequent bending and reaching.
• Must be able to tolerate a hot work environment seasonally, when summer outdoor temperatures combine with residual heat from machines.
• Must be able to walk within and between areas frequently and climb stairs occasionally.
  
  
  

MENTAL REQUIREMENTS:

• Must be able to understand and carry out written and verbal instructions.
• Must be able to comprehend and comply with detailed gage calibration work instructions and practices
• Must be able to retain instructions sufficient to perform complex tasks successfully and with very minimal supervision.
• Must be able to read and understand drawings and precision measuring instruments.
• Must be able to comprehend and comply with requirements of the Quality Systems Manual as instructed.