What are the responsibilities and job description for the Electronic Technician position at Matric Limited?
Electronic Technician
Job Duties:
- Observe ESD precautions to prevent damage to sensitive equipment.
- Visually inspect assemblies to determine if they are built to customer specifications. Identify faulty components, components installed incorrectly and detect other quality defects.
- Perform electronic testing of assemblies of basic to intermediate complexity.
- Be able to disassemble and reassemble units correctly.
- Perform basic electronic/ functional troubleshooting for assemblies of basic to intermediate complexity that do not pass the accepted test procedures.
- Adjust or replace defective components to meet established standards.
- Identify, prepare and correctly solder components to PC board. Become solder certified.
- Assemble prototype units.
- Maintain accurate records on paper and/or computer.
- Show competency in Matric Limited part numbering system.
- Practice safe work habits and report all safety hazards to the supervisor.
- Responsible for inspecting your work and identifying quality defects.
- Accountable for the quality and quantity of your work.
- Assist co-workers with problems encountered.
- Shall be instrumental in improving processes and in creative problem-solving.
Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions
Competencies:
To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required.
- Shall be familiar with and able to use the following hand tools: screwdriver, pliers, wire cutter, wire stripper, various small wrenches, etc.
- Shall be familiar with and able to use the following dimensional measuring tools: ruler, vernier caliper.
- Shall be familiar with and able to use the following electronic test equipment: variable autotransformers, volt-ohm-milliamp meter, oscilloscopes, power suppliers, hipot tester, impedence bridge, proprietary test equipment, signal generators, frequency counters, waveform generators, various analog and digital test sets, chip programmers.
- Able to read and interpret engineering drawings, schematic diagrams, and formulas and confer with management or engineering staff to determine quality and reliability standards.
Required Education and Experience
- High school or GED.
- Accepted electronics training - degree, technical certificate, vocational schooling and/or accepted correspondence course.
- Any equivalent combination of education and experience