End Welder Second Shift

Description

• Must be willing to work 2nd Shift.  50 hour week.  Mon - Fri 4 pm - 2:45 am, $1.50 per hour shift differential

• Responsible for wearing the proper mandatory safety      gear in designated areas/situations and assure all machine guards are in      place.
• Maintain compliance with all company policies,      procedures and OSHA guidelines.
• Acquire proper paperwork and verify measuring devices      prior to start of shift.
• Ensures that the correct slit coils, designated by      the work orders, are staged and ready for the production run. See supervisor for instruction or if      material is missing.
• Performs proper inspections of the materials      (thickness, width and appearance) and document on inspection sheets. 
• Inspect edges of strip to ensure that the burr of the      steel is in the proper orientation (normally burr up feeding into the      mill).
• Use End-Welder to join tailing end of coil to the new      coil being processed. Tails of coil      must be square to ensure proper alignment. If using mig welder to join      coils grind to smooth finish. Operator must inspect both sides of the weld      to ensure proper penetration has been achieved and that the weld is of      acceptable quality.
• Communicates with mill operator to estimate quantity      of steel needed for production run and forwards raw material tag to      operator for production report purposes.
• Performs      visual inspection of the floop to make sure steel is loaded/routed      correctly, all settings and air pressures are correct for the      material. Also checks to make sure      the correct amount of pressure is applied to the pinch rolls.
• Responsible for the upkeep, troubleshooting and      monitoring conditions of the equipment being utilized and reports any      problems or damages to supervision.
• Ensures that proper tools, welding parts, argon      tanks, tungsten, etc, are available at all times and properly      prepared/installed.
• Sees to cleanliness and assures a safe work      area. Stack pallets neatly and      store wood spacers in appropriate area.
• Perform related duties as assigned by supervisor

Requirements

Education and/or Work   Experience Requirements: 

· Ability   to work independently and to carry out assignments to completion within   parameters of instructions given, prescribed routines, and standard accepted   practices

· High   school diploma or GED preferred

Physical   Requirements: 

· This person is responsible for the safe and   correct operation of all the equipment in the End Welding area including   up-ender, overhead crane, uncoiler, welder, floop and lift truck. 

· Must be able to lift and carry up to 75 lbs

· Ability to maintain regular, punctual   attendance consistent with federal, state and local standards

PPE: 

Safety Glasses

Steel Toe Shoes (Slip Resistant) 

Gloves (Rubber or Leather)

Welding Mask

Helmet

Kevlar Sleeves

Ear plugs

Face shield or goggles

Salary : $16 - $17