Demo

Electronic Technician III

Jabil
Memphis, TN Full Time
POSTED ON 4/25/2026
AVAILABLE BEFORE 5/23/2026
JOB SUMMARY Responsible for maintaining and improving the RF technology proficiencies and efficiency for the Diagnostic department. ESSENTIAL DUTIES AND RESPONSIBILITIES

  • Exhibit proficient knowledge of RF (Radio Frequency) technology and testing concepts such as but not limited to the following: RF Modulation, Cellular technology concepts and principles, Wi-Fi, WIMAX.
  • Possess knowledge of the topology of RF components such as but not limited to Amplifier, Attenuator, Coupler, Filter, RF Switch, VCO.
  • Diagnose and repair to component level on electronic circuit board assemblies that have had prior repair attempts by Diagnostic Technicians I & II, while maintaining minimal quantities of Engineering and Component hold assemblies.
  • Exhibit proficiency in configuring and use of RF related test and measurement equipment such as but not limited to Oscilloscope, Spectrum Analyzer, Network Analyzer, Signal Generator, Power Meter.
  • Ability to understand and utilize assembly documentation such as but not limited to the following; Schematics, BOM’s, EC documents, Visuals, Debug, Testing tools and procedures.
  • Assist Test Engineering department in an ongoing data evaluation program for improving the efficiency of the diagnosis of assemblies.
  • Understand, recognize and execute Jabil production requirements, rules, policies and procedures.
  • Frequent customer interface, including travel to customer sites for advanced diagnostic issues.
  • Recommend design changes for product quality and yield improvement as well as Design For Test and Design for Diagnostics recommendations
  • Recommend Diagnostic technicians staffing levels, and assist in recruiting.
  • Assist and train technicians in any issues of a technical nature.
  • Works on technical assignments that are complex in nature where considerable judgment and initiative are required in resolving problems and making recommendations.
  • Determine document methods and procedures on new assignments and provide guidance to other personnel.
  • Perform as a team member to achieve Diagnostic department’s process yield goals.
  • Prepare reports and recommend solutions to technical problems as required.
  • Adhere to all safety and health rules and regulations associated with this position and as directed by supervisor.
  • Comply and follow all procedures within the company security policy.
  • May perform other duties and responsibilities as assigned. JOB QUALIFICATIONS KNOWLEDGE REQUIREMENTS
  • Ability to work with mathematical concepts such as probability and statistical inference, and fundamentals of plane and solid geometry and trigonometry.
  • Ability to apply concepts such as fractions, percentages, ratios, and proportions to practical situations.
  • Ability to effectively present information and respond to questions from groups of managers, clients, customers, and the general public.
  • Ability to define problems, collect data, establish facts, and draw valid conclusions.
  • Ability to operate a personal computer including using a Windows based operating system and related software.
  • Advanced PC skills, including training and knowledge of Jabil’s software packages.
  • Ability to write simple correspondence. Read and understand visual aid.
  • Ability to apply common sense understanding to carry out simple one- or two-step instructions.
  • Ability to deal with standardized situations with only occasional or no variables.
  • Ability to read and comprehend simple instructions, short correspondence, and memos.
  • Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
  • Ability to compute rate, ratio, and percent and to draw and interpret graphs., BE AWARE OF FRAUD: When applying for a job at Jabil you will be contacted via correspondence through our official job portal with a jabil.com e-mail address; direct phone call from a member of the Jabil team; or direct e-mail with a jabil.com e-mail address. Jabil does not request payments for interviews or at any other point during the hiring process. Jabil will not ask for your personal identifying information such as a social security number, birth certificate, financial institution, driver’s license number or passport information over the phone or via e-mail. If you believe you are a victim of identity theft, contact the Federal Bureau of Investigations internet crime hotline (www.ic3.gov), the Federal Trade Commission identity theft hotline (www.identitytheft.gov) and/or your local police department. Any scam job listings should be reported to whatever website it was posted in.

Salary.com Estimation for Electronic Technician III in Memphis, TN
$70,610 to $91,473
If your compensation planning software is too rigid to deploy winning incentive strategies, it’s time to find an adaptable solution. Compensation Planning
Enhance your organization's compensation strategy with salary data sets that HR and team managers can use to pay your staff right. Surveys & Data Sets

What is the career path for a Electronic Technician III?

Sign up to receive alerts about other jobs on the Electronic Technician III career path by checking the boxes next to the positions that interest you.
Income Estimation: 
$53,549 - $70,380
Income Estimation: 
$58,869 - $76,887
Income Estimation: 
$67,090 - $86,754
Employees: Get a Salary Increase
View Core, Job Family, and Industry Job Skills and Competency Data for more than 15,000 Job Titles Skills Library

Job openings at Jabil

  • Jabil Florence, KY
  • Location: Florence, KY (CVG 200) Shift: Sun.-Tues./Sun.-Wed. 6am-6pm (401/A) Job Summary Industrial Eng Tech II will support the Industrial Engineering Dep... more
  • 1 Day Ago

  • Jabil Florence, KY
  • Jabil’s Florence, KY facilities are experiencing growth to support the manufacturing of servers. We are actively hiring to increase production. Please appl... more
  • 1 Day Ago

  • Jabil Florence, KY
  • Summary Responsible for the Automated Optical Inspection (AOI) verification and testing of electronic circuit board assemblies. ESSENTIAL DUTIES AND RESPON... more
  • 1 Day Ago

  • Jabil Florence, KY
  • Job Summary Responsible for the verification testing, diagnosing and repairing of electronic circuit board assemblies. Essential Duties And Responsibilitie... more
  • 1 Day Ago


Not the job you're looking for? Here are some other Electronic Technician III jobs in the Memphis, TN area that may be a better fit.

  • Vector Security and Vector Security Networks Career Opportunities Jackson, TN
  • At Vector Security We Think Big, Do the Right Thing, and Make a Difference Every Day! If this is how you like to work, we’d like to invite you to join our ... more
  • 1 Day Ago

  • Jabil Memphis, TN
  • JOB SUMMARY Responsible for the 5DX verification testing, diagnosing and repairing of electronic circuit board assemblies. ESSENTIAL DUTIES AND RESPONSIBIL... more
  • 2 Days Ago

AI Assistant is available now!

Feel free to start your new journey!