What are the responsibilities and job description for the Electrical Maintenance Technician position at AAL STAFFING SERVICE, LLC?
- Troubleshoot electrical issues on presses and blenders in Molding: i.e. controller not functioning, proximity switches not working, rack switches, gate switches, nozzle heaters, heat detectors, pump or clamp not working properly, safety gates, switches and devices, thermocouple repair/replacement, etc.
- Troubleshoot electrical issues in Lining and Palletizing: i.e. feed eyes not working, elevator wiring, camera power supply and belt, camera reject eye, strobe not working, glue sensors, Alan Bradley system,
- Miscellaneous electrical troubleshooting: i.e. verify voltage, power outage, wiring/rewiring, fuse/circuit breakers, drives, encoders, sensors, breakers, switches, motors, e-stops, interlocks, etc.
- Fabrication of electrical and mechanical equipment
- Controller PM and calibration
- Maintenance of programmable logic controllers, relays, contactors, motor starters, and other related equipment.
- Verify, repair or replace e-stop and interlock functions on all equipment
- Read schematics and wire, rewire as needed
- Access NRC-0 and NRC-1 rated electrical panels
- (**) Disconnect or shutoff electrical current for NRC-2 or NRC-3 rated panels
- (**) Update one-line drawings and verify Arc Flash and NRC rating of panels are properly and correctly labeled.
- (**) Identify Arc Flash boundaries for high risk areas.
- (**) Assist with identifying appropriate LOTO requirements for isolating energy sources on equipment. Verify no current with approved Fluke meter.
- General mechanical duties as requested including operation of basic hand tools.
- Follow all safety procedures while performing tasks such as Hot Work, Confined Space, LOTO, Electrical Safety, etc.
- Complete Work Orders and document work (electronic or paper)
- Promote plant goal’s, such as Safety/Housekeeping, Quality, ISO, and GMP.
Supervisory Responsibilities
This job has no supervisory responsibilities.
Education and/or Experience
High school diploma or general education degree (GED); and twelve months related experience and/or training; or a combination of education and experience of at least twenty-four months.
Electrical safety and arc flash training per NEC, NFPA70E, OSHA and IEEE1584. Herzig Engineering
Work Location: In person